MICROSTRIP SYSTEMS TRAINER
PROFILE
We Amitec are one of the well known manufacturers and exporters of Synthesized Signal Generators, Noise Generators, Sweep Generators, RF Generators, Microstrip Systems Trainer, etc. globe.
Microstrip Systems Trainer (50 - 1300MHz)
Microstrip Systems Trainer has been designed for teaching and measuring various parameters associated with solid state microwave applications ranging from land and mobile communications to high-speed computing and data transmission.
Microstrip Systems Trainer comprises of Synthesized Receiver with built-in Tracking Generator, 2 Microstrip Antennas and 17 Microstrip Components (passive & active components), terminations, connectors and cables required to construct the commonly used configurations.
Microstrip Analysis Software offers comprehensive measurement functions.
Key Specifications
Receiver Synthesized with RF Source
The receiver has a built-in tracking generator with a frequency range of 50 to 1300MHz. Wide dynamic range (100dB), 0.1dB resolution, 3dB typical level accuracy, 50KHz frequency resolution and narrow resolution bandwidth (300KHz typical) allow accurate spurious free measurements. The receiver has a serial port (RS232) for computer interface.
Microstrip Components
There are 13 passive devices, 2 microstrip antennas and 4 active devices as listed below.
PASSIVE Devices
1) Two way equal power
2) Four way equal power
3) Two way un-equal power
Directional Coupler
4) Two branch
5) Three branch
6) Coupled Line
7) Rat Race
Filters
8) Low Pass
9) Band Pass
10) Band Reject (Notch)
Other Components
11) Rectangular Resonator
12) Attenuator 6dB
13) Circulator - Isolator
Active Devices
14) Amplifier
15) Oscillator (VCO)
16) Mixer
17) Pin Diode Switch
Microstrip Antennas - 2 nos
Accessories
The accessories comprise of Directional Coupler, Impedance Matching Tuner, Terminations (short, open, 50 ohms) and various adapters and cables.
Software
• VSWR vs Frequency Mode
• Spectrum Mode
• Network Analysis (Scalar)
• S-Parameters (Scalar) optional feature
