Down-converter : 479.5 Mhz output for spectrum
analysis
Telemetry : 4 bit binary LED output with
Selectable 4 addresses
Valid/Error : Tele-command Frame available at
Correction digital output
RSSI Out : Received signal strength output for
C/N measurement
Frequency : 2.4, 2.427, 2.454 & 2.481 GHz
PLL Synthesized ISM Band
Display : 16X2 LCD Backlit
RF Input Z : 75 Ohms Unbalanced
Sensitivity : -85dBm
Uplink Path Loss: 20dB typical variable attenuation
Telemetry : 4 bit binary LED output with
Selectable 4 addresses
Valid/Error : Telemetry Frame available at
Correction digital output
Frequency : 2.4, 2.427, 2.454 & 2.481 GHz
PLL Synthesized ISM Band
Display : 16X2 LCD Backlit
Spurious output : - 30 dB typical
RF Output Z : 75 Ohms Unbalanced
RF output level : +3 dBm nominal
Path Loss : Upto 25dB variable attenuation
Tele-command : Selectable 4 bit binary input with
selectable 4 addresses
Enable : Telecommand Frame available at
digital input
Test Output : Audio 1, Audio2, Video, Digital
Down-converter : To spectrum analyzer 479.5 MHz
RSSI Out : Received signal strength output for
C/N measurement
Band limiting : 18MHz fixed typical
Noise addition : Variable
Signal delay : upto
Signal fading : Variable 10dB
Antennas : Microstrip Yagi X2,
Helix LHCP X2 & RHCP X2,
Microstrip Patch X2,
25 cm dia Parabolic reflector with
0.25 f/d typical X2
Mount : Antenna mount X2
Software : PC Serial communication software
Accessories : Camera, Microphone, monitor,
Cables BNC-BNC X6, Tee
connector X2, RS 232 Rx & Tx
Cables
Amitec STC24 Technical Specifications
Suggested related equipments:
List of Experiments:
* To set up an active & passive satellite
communication link and study their difference. To
study the advantages of satellite communication. To
study the communication satellite link design:
process of transmitting a signal to a satellite
(UPLINKING), reception of same signal via satellite
(DOWN LINKING) and functioning of transponder
of a satellite.
* To measure the baseband analog signal
parameters in a satellite link.
* To measure the signal parameters in an analog
FM/FDMTV Satellite link.
* To study the functionality of a satellite MODEM.
* To study the phenomenon of Linear and Circular
polarization of antennas.
* To measure the C/N ratio.
* To measure the S/N ratio.
* To study the effect of fading and measure the fading
margin of a received signal.
* To measure the Propagation Delay of signal in a
satcom link.
* To measure the digital baseband signal parameters
in a satcom link. To measure the range of baud rates
that the system can support.
* To send telecommand and receive the telemetry
Data and study the operation of a codec
* To setup a RS-232 satellite communication link
using RS 232 ports.
* To calculate Bit Error Rate in a satcom link.
::
Antenna design and simulation software
: Antenna training Lab ATS20
: Antenna Analyser ATS10
: Microwave Antenna Training System MAT10
: Wireless Comm. Training System WCT24
: Satellite Communication Training System STC24
: MIC Analyser MIC10
: Scalar Network Analyser SNA05
: Microwave Frequency Counter FCM10
: Transmission line Analyser TLA05