Amitec Scalar Network Analyser SNA05
Amitec SNA05 Features
Amitec Model SNA05 scalar network analyzer is
designed to allow you to actually SEE the Electronic
Spectrum
frequency domain to get the complete picture. The
modulation products and sidebands of AM, FM, SSB,
DSB, DSB-SC, VSB waveforms can be studied. The
frequency range and high sensitivity is suited to
EMI/EMC measurements, both radiated and
conducted. This aids both identification of signals,
particularly background, and the location of problem
emissions. A tracking signal source along with
directional coupler can be used to measure any two port
network. Different training modules are provided for
study and experimentation.
in "real time". It can be used for analysis in
:
* 10MHz to 500MHz measurement range
* Waveform and modulation independent
* Low cost with high performance
* Inbuilt frequency counter
* Wide input range -70dBm to +20 dBm
* RF modules for experimentation
* Tracking signal source for network analysis
Amitec SNA05 Technical Specifications
Frequency 10 MHz – 500 MHz
Center frequency 4 digit LED display
Accuracy + 0.1%
Resolution 100KHz
Sensitivity -70dBm
Attenuator 40 & 20dB External
Input Impedance 50 Ohms (BNC)
Horizontal scan upto 50MHz/div continuous
Center freq. Variable control
CRO Output Linear X out (BNC)
Log Y out (BNC)
Tracking signal -5dBm Typical
Impedance 50 Ohms
Attenuator 40 & 20dB External
Power Supply 220V + 10%, 50Hz AC
Accessories Mains Lead, BNC-BNC
1. Amplifier Gain/freq adjustable
2.3. RF Oscillator Colpitts/Hartley
4.5. Crystal Oscillator Feedback/Colpitts
6. Frequency multiplier
7.8. IF amplifier FM/VIF
9.10. HPF Butterworth/Chebychev
11.12. LPF Butterworth/Chebychev
13.14. BPF Butterworth/Chebychev
15. Bandstop Filter
Directional coupler 10-500 Mhz
E-Manual: Installation Video for ease of Learning
(OPTIONAL) Training Modules